How Can I Replace A Broken Garage Door Spring?

garage-door-spring-repair-Glen-Allen

Replacing a broken garage door spring in Glen Allen can be a daunting task. It requires knowledge, the right tools and sometimes even physical strength. However, with careful planning and preparation, it’s possible to complete this repair project on your own without professional help. Here are some tips to help you successfully replace your broken garage door spring.

garage-door-spring-repair-Glen-Allen

  1. Invest in the proper tools for the job and make sure you have enough strength to lift, lower and handle the spring. You will need a winding bar, hammer, an adjustable wrench or socket set and a ladder. Depending on how your door is constructed, you may also need pliers and screws.
  2. Put on protective eyewear and gloves before beginning the repair. Make sure to also clear any debris or objects that may be near the door and area where you are working.
  3. Disconnect the power source from your garage door opener before attempting any work. This is a critical safety step, as injuries from springs that suddenly release can be serious.
  4. Mark and measure the length of your old spring, then purchase a new one with the same size measurements.
  5. Loosen the hardware on both sides of the spring to remove it safely, making sure not to touch any other components in the process.
  6. Attach the new spring where you removed the old one. Make sure it is properly secured.
  7. Wind the new spring using a winding bar and gradually increase tension on the spring until it is tight enough to support the garage door’s weight.
  8. Reattach your power source to your garage door opener, then test the operation of your newly replaced door.

With the right tools, careful preparation and a bit of patience, you can replace your broken garage door spring with ease. Following these steps will help ensure that your repair project goes off without any issues.

Posted in GarageGarage Door Spring Repair